This is the first time I have used the SlixxShot nipples on a Uberti firearm. After taking the new gun apart to inspect and clean the action up, I replaced the factory nipples with SlixxShot nipple. I shoot frontiersman in SASS meets and must have 100% reliability. I used 20 gr Goex with a .375 RB and CCI #11 caps. I shoot a total of 40 shot with ZERO misfires or jams. If you shoot cap and ball, you got to have these.

A great way to up grade your revolvers and will improve your over all gun or guns fit is good and installation is simple will replace all of mine with these. Thanks Slixprings
Craig

I received my order very quickly. Within 3 days. Gave to my son as a gift and he was very pleased with the quality

The nipples work great! The pistol goes bang. if and when I get a second you can bet it will have slix nipples on it.

Greatly reduced cap sucking in both my Uberti 1860 and 1851. Perfect fit and quality is as good as my Track of the Wolf and Treso AMPCO nipples. Was able to use Remington #10, CCI #11 and RWS 1075 #11 with no issue. RWS are a little tight but a light push with a wooden dowel and they seat fine. Wish they made them for the 1862 pocket model!

Great upgrade to my revolver!

Found a Remington 44 cal in the mud, rusty nipples rusted in . After weeks of soaking finally got them out but distroyeded the nipples Slixshot nipples replaced them and they work perfect.

The nipples I purchased fit easily in the cylinder and have made cap sucking almost a thing of the past , they are a must have if your caps are getting sucked into the hammer and the dark places. Thanks for the fast service.

Word is that stock Uberti nipples are made for European caps, so if you want to use #10 caps, or similar, then you need American nipples, and these work great. I bought a revolver that fired from 4 of 6 chambers, and now it's fixed. Probably doesn't hurt to make sure the mainspring is tight either.

I have two Ruger Old Armies with a total of 12 Cylinders and I shoot them quite a lot. I have never had a cap jam with these nipples.

These are very good nipples, and have added some reliability to my 1851 Uberti.

I installed these on a pietta remington navy that is about 27 years old. The original nipples were worn significantly.

Your product restored this old revolver quite nicely. No more hammer blowback, cap jams or misfired.

Now I need a set on my old Uberti navy it seems.

great service great product

If you know, you know. Don't waste your time elsewhere. These are marked to fit remington #10 caps, but also accept cci #11 very snugly in my experience. My first upgrade to any new BP revolver is now to get these nipples.

I have put the SlixShot nipples on all four of my BP revolvers. I have not had any problems with caps being stuck since then.

I used to compete in CAS with Pietta 1851 Navy revolvers and once I switched to SliXshot Black Powder Nipples I never had a cap jam again. What other product can make a claim like that?

I bought 3 sets for my pietta pistols. They fit my Remington find but was two long for my colt style guns. Luckily I have 3 new model armies

I have used the slix-hand, combo driver and nipple wrench, and multiple sets of slixshot nipples. Every item i have been pleased and impressed with. Great design, engineering, high quality. Will buy again happily.

These are great. No more cap jams or misfires. I now have a set on all of my cylinders.

Very well made product, probably will purchase more in future, only gave 4 stars because I haven't actually fired them yet

I have bought 3 sets; 1 for my pietta 51 navy I haven't tried yet but the other 2 were for my uberti 1849 pocket and my uberti 51 navy London and I have never seen anything like them. my 49 pocket used to have a cap jam every other shot but now it works great.you should sell a set of 5 for the 1849s they screw in and seat fine on newer models I believe it is the older models that they don't fit on but both of mine were made in 2019 and 2020

Reply from SliXprings:

We are aware of the 1849 model and are designing a nipple that will work on the new and older 1849’s and 1862’s. Hoping to have them available around February of 2021.

I ordered a two sets of nipples which are great quality they noticed i was in the same town and refunded my shipping to deliver them to me for free and when i was installing them on my revolvers my wrench broke so i ordered a new wrench and they delivered them to me on the same day also the new nipples help with the caps falling off when firing i will go to them for any blackpowder purchase first

Great!! Cap jams were a constant aggravation, and these certainly fixed that problem. On top of that I'm a veteran and look to support veteran owned businesses. Top quality product from a true patriot! Thanks!!

installed a set in my uberti 1860 army...have 100% ignition now, without any jams from caps falling into the action. I use remington #10 caps.

Got what I ordered in a decent time.
Thanks