here to purchase
For Smoother more Dependable LEVER
Winchester 1860, 1866 & 1873’s
- made by Uberti
Tired of wearing the cams off of the finger and carrier levers in your
Tired of having to continually re-arch and/or reset the load on your
replacement lever springs?
Want a smoother, more solid feeling, and improved action for your edge
The Cowboy Action
TK4B Enterprises have completely redesigned and engineered set of SliXprings
to provide a smoother, trouble free competitive replacement lever spring
These .076” lever
springs are made from 100% music wire alloy and have been tested and
determined to significantly reduce wear on the cam surfaces of both the
finger lever and the carrier lever.
The .076” wire size more closely reflects the wear surface
diameter of the original springs (both clone and original) and therefore
is more tolerant of any wear or pitch variations from manufacturing
tolerances. The larger
radius at the “Tab” also adds significantly to a smoother and more
In addition, the
.076” wire is approximately 3-1/2 times less likely to fatigue or lose
its “set” over time. This spring material has been tested to over
900,000 equivalent lever cycles without any lose of tension. However,
should either “set” or
natural fatigue occur, the spring kit design allows for easy adjustment
to return the action to its best operating pressures.
The Kit is also designed for the installer to not only easily fit
it, but also to be able to very finely tune the carrier spring
pressure to adjust for different caliber and bullet weights to guarantee
the smoothest uninterrupted action.
Likewise the finger lever side can also be finely adjusted to
allow for any lever modifications or the added weight of a protective
Each Kit contains a
complete spring set and both screws and a set of instructions for the
more capable home tuner.
plus S & H
Made in The
United States of America
here to purchase